Airbi CONTROL

Each measuring instrument has a measurement accuracy deviation. For temperature, this deviation is most often ± 1 °C, for humidity ± 5 % rH (relative humidity). If these deviations are added together, the measured values ​​can often differ significantly. In addition, it is necessary to ensure the same conditions at the same location during the comparison.

Never place the indoor measuring instrument near a heater or window.

In general, the device should be located where the air flows freely and where it is as little affected by external influences (outside air, sunlight, heating, etc) as possible.

This is caused by poor communication between the wireless sensor and the main unit. The reason may be:

• poor condition of the batteries in the sensor or main unit (never use rechargeable batteries, they have a different voltage than normal alkaline or lithium batteries),
• the distance between the sensor and the main unit is too large, shorten the distance between them,
• signal interference on the route between the sensor and the main unit, try moving the sensor to another location where there is no source of interference.

Follow the operating instructions to re-establish the signal between the sensor and the main unit.